Stainless steel floor drain W300, two-piece

Stainless steel floor drain W300, two-piece

2-part drain made of stainless steel AISI 316L (1.4404) with a plate thickness of 1.5 mm. The round well housing with a diameter of 295 mm, a telescopic grid attachment with a diameter of 255 mm, is seamlessly deep drawn and has rounded corners at the height of the bottom plate. It is adjustable in height between 90 and 145 mm, it is rotatable through 360° and 6° tiltable. The drain has a vertical or horizontal outlet 110/160mm and an inspectable stench trap with EPDM seal, in accordance with European standard EN 1253. The well housing and stench trap are designed in such a way that no waste water remains in the well body, but only in the stench trap. according to EHEDG. The height of the water seal is 50 mm in accordance with EN1253. With clamping flange, 100 mm wide and sealing and drainage ring. The top surface is square, 300 x 300 mm. Pressed top surface without welds and rounded corners. The outer edges are folded in an inverted folded U-edge with solid stainless steel full material edge reinforcement against mechanical and thermal stress in accordance with EHEDG. The drain has a dirt trap (capacity 2.9 l) with handle. After folding and welding, the whole is pickled by immersion and passivated. The circumferential top edge is ground with 240 grit. The drain is equipped with set screws, anchoring and grounding.

Documentation folder

DOWNLOAD THE DOCUMENTATION FOLDER HERE